加入收藏| 设为首页
00852-35950288
网站公告: The neweset Android solution
芯片/晶片 (ICs) >> 返回 您当前所在位置:首页 > FTDI > 芯片/晶片 (ICs) > 正文

FT201X

更新时间:2012-09-09 16:00:00点击次数:1968次字号:T|T
FT201X – 全速 USB to slave I2C
相关介绍
FT201X 規格書下載

  • Single chip USB to I2C interface.
  • Entire USB protocol handled on the chip. No USB specific firmware programming required.
  • Fully integrated 2048 byte Multi-Time-Programmable (MTP) memory for storing device descriptors and CBUS I/O configuration.
  • Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA.
  • 512 byte receive buffer and 512 byte transmit buffer utilising buffer smoothing technology to allow for high data throughput.
  • FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
  • Configurable CBUS I/O pin.
  • Battery Charger Detection. May be used by mobile devices to detect the presence of a charger on the USB port to enable higher current / faster charging of batteries.
  • Device supplied pre-programmed with unique USB serial number.
  • Supports bus powered, self powered and high-power bus powered USB configurations.
  • Integrated +3.3V level converter for USB I/O.
  • True 3.3V CMOS drive output and TTL input.
    • (Operates down to 1.8V with external pull ups and is also 5V tolerant)
  • Configurable I/O pin output drive strength.
  • Integrated power-on-reset circuit.
  • Internal 3.3V/1.8V LDO regulators
  • Low operating current  of  8mA (typical)  and USB suspend current of  125uA (typical) current.
  • Low USB bandwidth consumption.
  • UHCI/OHCI/EHCI host controller compatible.
  • USB 2.0 Full Speed compatible.
  • Extended operating temperature range: -40°C to 85°C
  • Pb-free 16 Pin QFN/SSOP packages (RoHS compliant).

地 址:香港觀塘鴻圖道57號南洋廣場905室

電郵: about@passiontech.net

Tel: 00852-35950288